Preliminary Procedures

1. Place the rear door window in the fully down position.
2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement.

1

Rear Door Window Regulator Retaining Bolts Bolt (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Procedure

1. Remove the rear door water deflector.
2. Position the window to view the window to regulator retaining pin, Do Not remove the window.

Refer to Rear Side Door Window Replacement

3. Use a suitable tool, insert the tool through the upper slot 1 in the window regulator arm and through the window guide releasing the window.
4. Tape the window to the up door frame to keep in place.

Tighten
10 N·m (89 lb in)

2

Rear Door Window Regulator

Procedure

Disconnect the electrical connector.