Important: Do not apply battery voltage to a new sunroof motor/actuator prior to installing the motor/actuator to the sunroof module assembly.

The sunroof window must be in the full closed position.

1. If possible, close the sunroof window before removing the sunroof motor/actuator.
2. It is only necessary to lower the headliner to gain access to the sunroof motor/actuator. Refer to Headlining Trim Panel Replacement .



3. Disconnect the electrical connectors (3) from the sunroof motor/actuator (1).
4. Remove the bolts (5) attaching the sunroof motor/actuator (1) to the sunroof module assembly (2).
5. Remove the sunroof motor/actuator from the sunroof module assembly (2).

1. Manually move the sunroof window to the full closed position.
2. Install the sunroof motor/actuator (1) to the sunroof module assembly (2).

Notice: Refer to Fastener Notice in the Preface section.

3. Install the sunroof motor/actuator bolts (5) to the sunroof module assembly.

Tighten
Tighten the bolts to 5 N·m (44 lb in).

4. Connect the electrical connectors (3) to the sunroof motor/actuator (1).

Important: Verify the sunroof operation before installing the headliner.

5. After installing the motor actuator, refer to Sunroof Motor/Actuator Initialization/Teach Process .
6. Install the headliner. Refer to Headlining Trim Panel Replacement .