Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0121: Valve Relay CircuitCircuit/System Description
An internal solenoid valve relay in the electronic brake control module (EBCM) supplies battery positive voltage to all solenoid valves. This voltage is referred to as system voltage. The EBCM activates the solenoid valve relay when the ignition is turned ON. Once the solenoid valve relay has been activated, The EBCM supplies ground to actuate individual solenoid valves.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | Ignition voltage is greater than 8 volts. |
Conditions for Setting the DTC
One of the following conditions exists for 0.23 second:
| • | The EBCM commands the solenoid valve relay on and battery voltage is not present at the solenoid valves. |
| • | The EBCM commands the solenoid valve relay off and battery voltage is present at the solenoid valves. |
Action Taken When the DTC Sets
| • | The EBCM disables the ABS system. |
| • | The ABS indicator illuminates. |
| • | DRP function is degraded. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
The solenoid valve relay is integral to the EBCM. The relay is not serviceable.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Verification
Verify DTC C0121 is not set.
| ⇒ | If the DTC is set, clear the DTC and operate the vehicle within the Conditions for Running the DTC. If the DTC resets, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
