Removal Procedure
Note: The driver door window regulator and motor MUST be replaced as an assembly. The right door is serviceable as door window regulator or motor.
- Remove the front door trim panel. Refer to
Front Side Door Trim Panel Replacement.
- Remove the front door water deflector. Refer to
Front Side Door Water Deflector Replacement.
- Raise the window far enough in order to gain access to the bolts (1, 2) that attach the window to the regulator.
- Remove the bolts (1, 2) that attach the window to the regulator.
- Raise the window to the full up position and tape in place.
- Disconnect the electrical connector (2) from the power window motor.
- Remove the front door window regulator. Refer to
Front Side Door Window Regulator Replacement.
- Remove the window regulator and motor through the access opening in the inner panel.
- Remove the power window motor bolts from the window regulator.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
- Install the power window motor bolts to the window regulator and tighten to
6 N·m (53 lb in).
- Install the window regulator and motor through the access opening.
- Install the front door window regulator. Refer to
Front Side Door Window Regulator Replacement.
- Connect the electrical connector (2) to the power window motor.
- Remove the masking tape.
Lower the window far enough in order to gain access to the bolts (1, 2) that attach the window to the regulator.
- Install the bolts (1, 2) that attach the window to the regulator and tighten to
10 N·m (89 lb in).
- Inspect the window for proper operation.
- Install the front door water deflector. Refer to
Front Side Door Water Deflector Replacement.
- Install the front door trim panel. Refer to
Front Side Door Trim Panel Replacement.