The security indicator is controlled by the body control module (BCM) based on commands from the immobilizer system or the content theft deterrent (CTD) system. With the ignition OFF, the security indicator is commanded by the CTD system. With the ignition ON, the security indicator is commanded by the immobilizer system.

The security indicator is located in the instrument panel cluster (IPC) and is supplied B+ at all times. When the immobilizer or CTD system requests the indicator be commanded ON, the BCM grounds the security indicator control circuit, illuminating the indicator.

Schematic Reference

Theft Deterrent System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Content Theft Deterrent (CTD) Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Ignition ON, command the security indicator ON and OFF with a scan tool. The security indicator should turn ON and OFF when changing between the commanded states.

1. Ignition OFF, disconnect the harness connector at the IPC.
2. Connect a test lamp between the control circuit terminal 10 and B+.
3. Command the security indicator ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

⇒	If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.

⇒	If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

4. If all circuits test normal, replace the IPC.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for BCM or IPC replacement, setup, and programming