1

3-5 Reverse Clutch Apply Plate (Waved)

2

3-5 Reverse Clutch Plate (Qty: 3)

3

3-5 Reverse Clutch Plate Assembly (Qty: 3)

4

3-5 Reverse Clutch Backing Plate

5

3-5 Reverse Clutch Backing Plate Ring Retainer Ring

1

3-5 Reverse Clutch Piston Dam Seal (Black)

2

3-5 Reverse Clutch Piston Inner Seal

3

3-5 Reverse Clutch Piston Inner (Reluctor) Seal (Orange)

4

3-5 Reverse Clutch Piston Return Spring Assembly

5

3-5 Reverse Clutch Piston

6

Input Shaft Speed Sensor Reluctor Wheel

7

Input Shaft Speed Sensor Reluctor Ring Retainer Ring

Caution: Compress the reluctor wheel just enough to clear the retainer. Over compressing the reluctor wheel will break the alignment tab and the clutch housing.

Caution: Regulate the air pressure to 40 psi maximum. High pressure could cause the piston to over travel and damage the piston seals.

Tip
Place the housing assembly onto the input shaft support inside the case. Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation.

Special Tools

DT-47694 Piston Spring Compressor

1

4-5-6 Clutch Piston Inner Seal

2

4-5-6 Clutch Piston Outer Seal (Large) (Rounded)

3

4-5-6 Clutch Piston Outer Seal (DK Blue) (Stepped)

4

4-5-6 Clutch Piston

Tip

Special Tools

1

4-5-6 Clutch Piston Return Spring Assembly

2

4-5-6 Clutch Piston Fluid Dam Assembly

Tip
DT-47951-1 seal protector prevents the dam seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of DT-47951-1 protector to ease the installation of the dam.

Special Tools

DT-47951-1 Seal Protector

3

4-5-6 Clutch Dam Retaining Ring

Caution: Regulate the air pressure to 40 psi maximum. High pressure could cause the piston to over travel and damage the piston seals.

Tip

Special Tools

DT-47951-2 Spring Compressor

1

Reaction Carrier Hub Thrust Bearing Assembly

2

Reaction Carrier Hub Assembly

3

4-5-6 Clutch Wave Plate

4

4-5-6 Clutch Apply Plate

5

4-5-6 Clutch Plate Assembly (Qty: 4)

6

4-5-6 Clutch Plate (Qty: 3)

7

4-5-6 Clutch Backing Plate

8

4-5- 6 Clutch Backing Plate Retaining Ring

1

Turbine Shaft

2

Turbine Shaft Retainer Ring

Tip
Do not re-use the turbine shaft retainer ring.

Special Tools

J-5586-A Snap Ring Pliers or equivalent