GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Malibu 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Crankshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1890116 Size: SH
  1. Remove the starter. Refer to Starter Motor Replacement.
  2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.

    3. Object Number: 1578475 Size: SH
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.

Installation Procedure

    Object Number: 1578475 Size: SH
  1. Lubricate the CKP sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the CKP sensor bolt and tighten to 10 N·m (89 lb in).

    4. Object Number: 1890116 Size: SH
  4. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
  5. Install the starter. Refer to Starter Motor Replacement.
  6. Perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn.