GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu Classic 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Rear Side Door Window Regulator Replacement

Removal Procedure

    Object Number: 1220817 Size: SH
  1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  3. Raise the rear door window far enough in order to gain access through the inner door to the window to the window peg retainer. Refer to Rear Side Door Window Replacement .
  4. Remove the nylon peg from the rear door window to regulator.
  5. Raise the rear door window to the full up position.
  6. Tape the rear door window in the full up position.
  7. Disconnect the electrical connector.

    8. Object Number: 1233423 Size: SH
  8. Remove the bolts from the rear door window regulator (1).
  9. Remove the rear door window regulator from the rear door.

Installation Procedure

    Object Number: 1233423 Size: SH
  1. Install the rear door window regulator to the door.

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1220817 Size: SH
  2. Install the regulator mounting bolts (1).

    3. Tighten
    Tighten the rear door window regulator bolts to 10 N·m (89 lb in).

  3. Connect the electrical connector.
  4. Remove the tape from the rear door window.
  5. Lower the rear door window far enough to install the door window. Refer to Rear Side Door Window Replacement .
  6. Install the bolts to the rear door window regulator (1, 2).

    7. Tighten
    Tighten the window regulator bolts to 10 N·m (89 lb in).

  7. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  8. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .