Starter Replacement LZ4

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the torque converter cover bolts.
4. Remove the torque converter cover.



5. Disconnect the engine wiring harness electrical connector from the starter motor.



6. Remove the positive battery cable nut (3) from the starter solenoid.
7. Remove the positive battery cable (1) and the engine wiring harness (2) terminal from the starter solenoid.



8. Remove the starter motor bolts.
9. Remove the starter motor.

1. Install the starter motor.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter motor bolts.

Tighten
Tighten the bolts to 43 N·m (32 lb ft).




3. Install the engine wiring harness (2) terminal and the positive battery cable (1) to the starter solenoid.
4. Install the positive battery cable nut (3) to the starter solenoid.

Tighten
Tighten the nut to 10 N·m (89 lb in).




5. Connect the engine wiring harness electrical connector to the starter motor.



6. Install the torque converter cover.
7. Install the torque converter cover bolts.

Tighten
Tighten the bolts to 10 N·m (89 lb in).

8. Lower the vehicle.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Starter Replacement L61

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the positive battery cable nut (1) from the starter solenoid.
4. Remove the positive battery cable (2) and the engine wiring harness (3) terminal from the starter solenoid.



5. Remove the starter solenoid "S" terminal nut (1) from the starter solenoid.
6. Remove the engine wiring harness terminal (2) from the starter solenoid.



7. Remove the starter motor bolts.
8. Remove the starter motor.

1. Position the starter motor to the engine block.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the starter motor bolts.

Tighten
Tighten the bolts to 53 N·m (39 lb ft).




3. Install the engine wiring harness terminal (2) to the starter solenoid.
4. Install the starter solenoid "S" terminal nut (1) to the starter solenoid.

Tighten
Tighten the nut to 3 N·m (27 lb in).




5. Install the engine wiring harness (3) terminal and the positive battery cable (2) to the starter solenoid.
6. Install the positive battery cable nut (1) to the starter solenoid.

Tighten
Tighten the nut to 10 N·m (89 lb in).

7. Lower the vehicle.
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .