For 1990-2009 cars only
Removal Procedure
- When replacing a weld joint molding do the following:
- Heat the molding using a heat gun. Apply heat using a circular motion for about 30 seconds.
- Use a plastic, flat-bladed tool to remove the weld joint molding from the panel surface.
- When replacing a molding, remove all adhesive as follows:
| • | Use tape to protect the mounting surface during removal. |
| • | Use tape for alignment marks for installation of the molding. |
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
| • | For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07502 or equivalent. |
| • | For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and water to remove the adhesive. |
Installation Procedure
- Heat the mounting surface to approximately 27-41°C (80-105°F) using the heat gun, if necessary.
- Ensure that the temperature of the molding is approximately 29-32°C (85-90°F).
- Remove the protective liner from the back of the molding.
- Position the molding to the location marks and press the molding to the mounting surface.
- Apply equal pressure along the molding to uniformly bond the item to the mounting surface.
- Remove the protective tape from the mounting surface.
Important: Apply the molding in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
Important: Do not touch the adhesive backing of the molding.
