Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

1. Turn the ignition switch to the OFF position.
2. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
3. Disconnect the electrical connector from the EBCM.



4. Remove the 4 EBCM-to-BPMV retaining bolts.
5. Separate the EBCM from the BPMV by carefully pulling apart.
6. Ensure the motor pin connector gets removed with the EBCM. A new motor pin connector comes with the replacement EBCM and should be replaced during service of the EBCM.

1. Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
2. Use care when aligning the EBCM to the BPMV electrical terminals . Install the EBCM to the BPMV.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the 4 EBCM-to-BPMV retaining bolts (1). Tighten the bolts in a cross pattern.

Tighten
Tighten the bolts to 5 N·m (44 lb in).

Important: Ensure the electrical connector is correctly inserted into the EBCM prior to swinging the assist locking lever into position. Failure to make a proper connection may cause communication problems with the module.




4. Connect the electrical connector to the EBCM.
5. If installing a new EBCM it is necessary to program the EBCM. Refer to Control Module References for programming and setup information.
6. Perform the Service Programming System (SPS).