Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle Floor Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Install the following 2 parts onto the steering shaft assembly:

1.1.	Lubricate the inner race (2) with lithium grease.

1.2.	Install the inner race (2).

1.3.	Install the upper bearing inner race seat (1).




2. Install the following 3 parts onto the steering shaft assembly.

2.1.	Install the upper bearing spring (3).

2.2.	Lubricate the turn signal cancel cam assembly (2) with lithium grease.

2.3.	Install the turn signal cancel cam assembly (2).

2.4.	Install the shaft lock (1).




3. Install the new bearing retainer (1) using J 23653-SIR .
4. Seat the bearing retainer (1) in the groove on the steering shaft assembly.
5. Remove J 23653-SIR .
6. Install the SIR coil assembly. Refer to Steering Shaft, Lower Bearing, and Jacket - Disassemble - Off Vehicle .

Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle Column Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Install the following 2 parts onto the steering shaft assembly:

1.1.	Lubricate the inner race (2) with lithium grease.

1.2.	Install the inner race (2).

1.3.	Install the upper bearing inner race seat (1).




2. Install the following 3 parts onto the steering shaft assembly.

2.1.	Install the upper bearing spring (3).

2.2.	Lubricate the turn signal cancel cam assembly (2) with lithium grease.

2.3.	Install the turn signal cancel cam assembly (2).

2.4.	Install the shaft lock (1).




3. Install the new bearing retainer (1) using J 23653-SIR .
4. Seat the bearing retainer (1) in the groove on the steering shaft assembly.
5. Remove J 23653-SIR .
6. Install the SIR coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .