1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in general information.
3. Disconnect the knock sensor wiring harness connector from knock sensor.
4. Remove the knock sensor from engine block.

Important:  Do Not apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensor's ability to detect detonation.

1. Install the knock sensor into engine block.
2. Connect the knock sensor wiring harness connector to the knock sensor.
3. Lower the vehicle.
4. Reconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.