Front Side Door Window Switch Replacement Coupe

Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

Important: Use protective coating/tape at the point of insertion of the flat surface tool.

1. Remove the switch plate assembly from the front door inner trim panel.

Use a flat-bladed tool.




2. Disconnect the electrical connector.



3. Unsnap the driver side front door power window switch from the mounting plate.



4. Unsnap the passenger side front door power window switch from the mounting plate.

1. Snap the passenger side front door power window switch into the mounting plate.



2. Snap the driver side front door power window switch into the mounting plate.
3. Connect the electrical connector.



4. Snap the passenger side switch plate assembly into the front door inner trim panel.



5. Snap the driver side switch plate assembly into the front door inner trim panel.

Front Side Door Window Switch Replacement Sedan

1. Remove the armrest pull cup mounting screw.




Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

Important: Use protective coating/tape at the point of insertion of the flat surface tool.

2. Remove the pull cup from the inner trim panel.

Use a flat-bladed tool.

3. Disconnect the electrical connector.



4. Unsnap the power window switch from the pull cup.

1. Snap the power window switch into the pull cup.
2. Connect the electrical connector.



3. Snap the pull cup into the inner trim panel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the armrest pull cup screw.

Tighten
Tighten the armrest pull cup screw to 3 N·m (30 lb in).