Tools Required

J 38536-A Antenna Bezel Socket

1. Open the rear compartment.
2. Remove the right side rear compartment trim in order to gain access. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.



3. Remove the antenna extension cable (3) from the antenna (4).
4. Remove the antenna mast (2). Refer to Fixed Antenna Mast Replacement .
5. Use the J 38536-A in order to remove the following components:

•	The antenna bezel (1)

•	The nut (5)

6. Remove the antenna (4).

1. Install the antenna (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Use the J 38536-A in order to install the following components:

•	The antenna bezel (1)

•	The nut (5)

Tighten
Tighten the nut to 10 N·m (89 lb in).

3. Install the antenna mast (2). Refer to Fixed Antenna Mast Replacement .
4. Install the antenna extension cable (3) to the antenna (4).
5. Install the right side rear compartment trim. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.
6. Close the rear compartment.