GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Monte Carlo 🢒 Engine 🢒 Engine Mechanical - 3.4L 🢒 Oil Level Indicator Tube Replacement

Removal Procedure

    Object Number: 187069 Size: SH
  1. Disconnect the spark plug wire from the spark plug adjacent to the oil level indicator tube.
  2. Remove the oil level indicator.
  3. Remove the oil level indicator tube bracket bolt from the oil level indicator tube bracket.
  4. Remove the oil level indicator tube.

Installation Procedure

    Object Number: 187069 Size: SH
  1. Clean the oil level indicator tube.
  2. Apply sealant around the oil level indicator tube 12.7 mm (0.50 in) below the bead. Use GM sealant P/N 12345739 or the equivalent.
  3. Install the oil level indicator tube into the engine block.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the bolt to the oil level indicator tube bracket.

    5. Tighten
    Tighten the oil level indicator tube bracket bolt to 25 N·m (18 lb ft).

  5. Install the oil level indicator.
  6. Connect the spark plug wire to the spark plug adjacent to the oil level indicator tube.