GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Monte Carlo 🢒 Engine 🢒 Engine Controls - 3.4L 🢒 Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure
  1. Turn OFF the ignition.
  2. Note the position of the EVAP hoses for installation.
  3. Disconnect the electrical connector and the hoses from the EVAP canister purge valve.
  4. Remove the bolt from the valve mounting bracket.

    5. Object Number: 576032 Size: SH
  5. Remove the EVAP purge valve.

Installation Procedure

    Object Number: 576032 Size: SH
  1. Position the EVAP canister purge valve on the manifold.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt and secure the EVAP canister purge valve.

    3. Tighten
    Tighten the bolt to 10 N·m (88 lb in).

  3. Connect the electrical connector and the hoses to the valve.