Ignition Control Module Replacement for Chevrolet Monte Carlo 2000

1. Disconnect the 14-way connector from the ignition control module.
2. Disconnect the spark plug wires from the coil assemblies.



3. Remove the screws (1) securing the coil assemblies to the ignition control module.
4. Remove the coils (2) from the ignition control module.
5. Remove the ignition control module.

1. Align the ignition control module on the mounting bracket.
2. Attach the coils (2) to the ignition control module. Refer to Ignition Coil Replacement .

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the ignition coils (2) and the attaching screws (1).

Tighten
Tighten the screws to 4-5 N·m (40 lb in).

4. Connect the spark plug wires.
5. Connect the 14-way connector to module.