Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you review the system operation and perform the necessary inspections? | -- | Go to Step 2 | Go to Symptoms |
2 |
Does the wiper keep running? | -- | Go to Step 5 | Go to Step 3 |
3 | Test for a short to voltage in the pigtail wires to the wiper/washer switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 4 |
4 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column - Tilt. Did you complete the replacement? | -- | Go to Step 12 | -- |
5 | Measure the voltage from the wiper/washer switch connector (vehicle side), terminal B6, to ground. Does the voltage measure greater than the specified value? | 1.0 V | Go to Step 9 | Go to Step 6 |
6 |
Does the voltage measure within the specified values? | 10.5-15 V | Go to Step 7 | Go to Step 8 |
7 | Repair the short to voltage in CKT 92. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 12 | -- |
8 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Did you complete the replacement? | -- | Go to Step 12 | -- |
9 |
Does the voltage measure greater than the specified value? | 1.0 V | Go to Step 11 | Go to Step 10 |
10 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Did you complete the replacement? | -- | Go to Step 12 | -- |
11 | Repair the short to voltage in CKT 113. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
