GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Monte Carlo 🢒 Body and Accessories 🢒 Body Control System 🢒 Roof Console Replacement

Removal Procedure

    Object Number: 546525 Size: SH
  1. Remove the screw from the overhead console.

    2. Object Number: 788716 Size: SH
  2. Use a small, flat-bladed tool in order to release the 2 retainers. These retainers are located on each side of the assembly in front of the switches. Press the retainers outward to release the assembly.

    3. Object Number: 546559 Size: SH
  3. Remove the overhead console from the headliner.
  4. Disconnect the electrical connectors from the overhead console.

    5. Object Number: 788711 Size: SH
  5. Remove the overhead console from the vehicle.
  6. Remove the screws from the drivers information center module.
  7. Remove the drivers information center module from the overhead console.

Installation Procedure

    Object Number: 788711 Size: SH
  1. Install the drivers information center module to the overhead console.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the drivers information center module screws.

    3. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 546559 Size: SH

    Important: When installing the overhead console, apply a foam type tape to the wiring harness to relocate and secure the wiring harness in the proper position to the headliner.

  3. Apply foam tape to the wiring harness at the headliner.
  4. Connect the electrical connector to the overhead console.

    5. Object Number: 546570 Size: SH
  5. Position the overhead console to the mounting bracket in the headliner.
  6. Install the overhead console pressing into place in order to fully seat the retainer tabs.

    7. Object Number: 546525 Size: SH
  7. Install the screw to the overhead console.

    8. Tighten
    Tighten the screw to 2 N·m (18 lb in).