1

Did you perform the Instrument Cluster Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool, perform the Volts Gauge Sweep Test.

Does the volt gauge move up and down when commanded?

--

Go to Diagnostic System Check - Engine Electrical in Engine Electrical

Go to Step 3

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

--

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2