GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Monte Carlo 🢒 Body and Accessories 🢒 Stationary Windows 🢒 Rear Window Reveal Molding Replacement

Removal Procedure

    Important: You must remove the rear window in order to replace the rear window reveal molding. The original rear window reveal molding must be replaced with a new service part after removal.


    Object Number: 293022 Size: SH
  1. Use a flat-bladed tool in order to pry the end of the rear window reveal molding out approximately 75 mm (3 in) from the body.
  2. Remove the rear window reveal molding, pulling the rear window reveal molding slowly away from the body.
  3. Remove the rear window. Refer to Rear Window Replacement .

Installation Procedure

    Important: The new rear window reveal moldings are primed and will adhere to the urethane adhesive.

    Use a heat lamp, or heat gun if needed, in order to make the rear window reveal molding more pliable.


    Object Number: 293022 Size: SH
  1. Wipe the rear window area with a clean, dampened cloth using GM Window Cleaner GM P/N 1050427 or isopropyl alcohol in order to clean the surface of the rear window for the installation of the new rear window reveal molding.

    2. Allow to air dry.


    Object Number: 401852 Size: SH
  2. Install the rear window reveal molding to the rear window, starting from the center , hand press the rear window reveal molding into place.
  3. Apply tape if needed, in order to keep the rear window reveal molding on the rear window.
  4. Install the rear window. Refer to Rear Window Replacement .