For 1990-2009 cars only
Removal Procedure
- Open the hood.
- Pull the rear side hood seal from the pinch-weld flange and motor compartment flange.
- Remove the rear side hood seal from the vehicle.
- Using 3M™ P/N 8984 Adhesive Remover or equivalent, clean any adhesive from the pinch-weld flange and motor compartment flange surface.
Installation Procedure
- Remove the protective backing paper from the adhesive on the rear side hood seal.
- Install the rear side hood seal to the pinch-weld flange and motor compartment flange.
- Press the side rear hood seal onto the pinch-weld flange and motor compartment flange until the adhesive is fully adhered.
- Close the hood.
