GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Monte Carlo 🢒 Body and Accessories 🢒 Seats 🢒 Front Seat Heater Control Module Replacement

Removal Procedure
  1. Remove the front seat adjuster to floor pan bolts.
  2. Tilt the seat forward.

    3. Object Number: 651902 Size: SH
  3. Disconnect the electric connectors from the heated seat module.

    4. Object Number: 651903 Size: SH
  4. Cut the tie straps to the module.
  5. Remove the heated seat module.

Installation Procedure
  1. Position the heated seat module under the seat.

    2. Object Number: 651902 Size: SH
  2. Connect the electric connectors to the heated seat module.

    3. Object Number: 651903 Size: SH
  3. Install new tie straps to the module.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the front bucket seat adjuster-to-floor pan bolts.

    5. Tighten
    Tighten the front bucket seat adjuster-to-floor pan bolts to 42 N·m (31 lb ft).