Tools Required
• | J 28467-B Universal
Engine Support Fixture |
- Raise the hood.
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
- Remove the cross vehicle brace. Refer to
Cross Vehicle Brace Replacement
in Body Front End.
- Remove the hood side rear seal from the
pinchweld flange (1).
- Install the J 28467-90A
onto the strut attaching studs.
- Install the strut tower support assemblies
J 28467-5A over the J 28467-90A
.
- Install the wing nuts to the J 28467-90A
.
- Install the strut tower tube J 28467-3
into the strut tower support assemblies J 28467-5A.
- Install the 1/2 inch x 2.5 inch quick release pin J 28467-10 through
the strut tower support assemblies J 28467-5A and the strut tower tube J 28467-3
on one side only.
- Install the radiator shelf tube J 28467-2A
on the top of the strut tower tube J 28467-3 on the driver side.
- Install the round tube of the front support assembly J 28467-4A
through the large hole in the radiator shelf tube J 28467-2A.
- Install the 7/16 inch x 2.0 inch quick release pin J 28467-9 through
the hole in the front support assembly J 28467-4A in order to level the radiator
shelf tube J 28467-2A.
- Install the cross bracket assembly J 28467-1A.
- Install the lift hook J 28467-7A through the lift hook bracket
J 28467-6A.
- Install the 1/2 inch lift hook washer and lift hook wing nut J 28467-34
onto the lift hook J 28467-7A.
- Install the assembled lift hook bracket J 28467-6A over the passenger
side radiator shelf tube J 28467-2A.
- Adjust the passenger side radiator shelf
tube J 28467-2A and the assembled lift hook bracket J 28467-6A in
order to align the hook with the left, rear of engine, lift hook bracket attached
to the left exhaust manifold.
- Install the lift hook J 28467-7A through the lift hook bracket
J 28467-6A.
- Install the 1/2 inch lift hook washer and lift hook wing nut J 28467-34
onto the lift hook J 28467-7A.
- Install the assembled lift hook bracket J 28467-6A over the strut
tower tube J 28467-3.
- Adjust the assembled swivel lift hook bracket
J 28467-8A in order to align the hook with the right, front of engine, lift
hook bracket attached to the right exhaust manifold.
- Hand tighten the cross bracket assembly J 28467-1A wing nuts.
- Hand tighten the lift hook wing nuts J 28467-34 securely to remove
all slack from the engine support fixture assembly.