Important Preliminary Checks Before Starting
Before using the Symptom tables, use the following:
| - | Ensure that the scan tool data is within normal operating range. Refer to
Scan Tool Data List
. |
| • | Verify the customer's complaint. |
| • | Perform the Visual and Physical Check in this section. |
Locate the correct symptom in the list at the end of this section. Follow the procedures in the appropriate diagnostic table. If the condition can not be duplicated, or is determined to be intermittent, refer to
Intermittent Conditions
.
Visual/Physical Check
Notice: Use the connector test adapter kit J 35616-A for any test that
requires probing the following items:
| • | The PCM harness connectors |
| • | The electrical center fuse/relay cavities |
| • | The component terminals |
| • | The component harness connector |
Several of the symptom procedures call for a careful inspection. This can lead to correcting a condition without further tests and can save valuable time. This inspection should include the following areas:
| • | Inspect the vacuum hoses for splits, kinks, and proper connections, as shown on Vehicle Emission Control Information label. Inspect thoroughly for any type of leak or restriction. Refer to
Emission Hose Routing Diagram
. |
| • | Inspect the air intake ducts for being collapsed, damaged areas, looseness, improper installation, or leaking, especially between the mass air flow (MAF) sensor and the throttle body. |
| • | Inspect for air leaks at throttle body mounting area, MAF sensor and intake manifold sealing surfaces. |
| • | Inspect the wiring harness for poor connections, pinches, cuts, or other damage. |
| • | Inspect for loose, damaged, or missing sensors/components. |
Use the following tables when diagnosing a symptom complaint:
