Exhaust Crossover Pipe Replacement 3.4L
Removal Procedure
- Remove the air cleaner intake duct. Refer to
Air Cleaner Inlet Duct Replacement
in Engine Controls - 3.4L.
- Remove the thermostat by-pass pipe. Refer to
Thermostat Bypass Pipes Replacement
in Engine Cooling.
- Remove the exhaust crossover heat shield bolts.
- Remove the exhaust crossover heat shield.
- Remove the exhaust crossover pipe nuts.
- Remove the exhaust crossover pipe.
Installation Procedure
- Install the exhaust crossover pipe.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the exhaust crossover pipe nuts.
Tighten
Tighten the nuts to 25 N·m (18 lb ft).
- Install the exhaust crossover heat shield.
- Install the exhaust crossover heat shield bolts.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Install the thermostat by-pass pipe. Refer to
Thermostat Bypass Pipes Replacement
in Engine Cooling.
- Install the air cleaner intake duct. Refer to
Air Cleaner Inlet Duct Replacement
in Engine Controls - 3.4L.
Exhaust Crossover Pipe Replacement 3.8L
Removal Procedure
- Remove the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
in Engine Mechanical - 3.8L.
- Remove the air cleaner intake duct. Refer to
Air Cleaner Inlet Duct Replacement
in Engine Controls - 3.8L.
- Remove the exhaust crossover heat shield nuts.
- Remove the exhaust crossover heat shield.
- Remove the exhaust crossover pipe bolts.
- Remove the exhaust crossover pipe.
- Remove the exhaust crossover pipe seal.
Installation Procedure
- Install the exhaust crossover pipe seal to the exhaust crossover pipe at the right exhaust manifold connection.
- Install the exhaust crossover pipe.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the exhaust crossover pipe bolts.
Tighten
Tighten the bolts to 20 N·m (15 lb ft).
- Install the exhaust crossover heat shield.
- Install the exhaust crossover heat shield nuts.
Tighten
Tighten the nuts to 20 N·m (15 lb ft).
- Install the air cleaner intake duct. Refer to
Air Cleaner Inlet Duct Replacement
in Engine Controls - 3.8L.
- Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
in Engine Mechanical - 3.8L.