| • |
Vehicles involved in accidents
involving the following conditions may also have a damaged or misaligned steering
column: |
| - | Major body or sheet metal damage |
| - | Where the steering column has been impacted |
| - | Where supplemental inflatable restraint systems deployed |
| • | Inspect the capsules on the steering column bracket assembly.
All capsules must be securely seated in the bracket slots and inspected for
any loose conditions when pushed or pulled by hand. |
| • | Observe how the bracket is attached to the jacket assembly. |
| - | If the capsules are not securely seated and the bracket is bolted
to the jacket assembly, replace only the bracket. |
| - | If the capsules are not securely seated and the bracket is welded
to the jacket assembly, replace only the jacket assembly. |
| • |
Inspect for jacket assembly
collapse by measuring the distance from the lower edge of the upper jacket
to a defined point on the lower jacket. Replace the jacket assembly if the
measured dimensions are not within specifications. |
| • |
Visually inspect the steering
shaft for sheared injected plastic (1). If the steering shaft shows
sheared plastic (1), replace the steering shaft. |
| • | Any frame damage that could cause a bent steering shaft must have
the steering shaft runout checked. Using a dial indicator at the
lower end of the steering shaft, rotate the steering wheel. The runout must
not exceed 1.60 mm (0.06 in). |
