Automatic Transmission Shift Lock Control Actuator Replacement Floor Shift
Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
- Remove the center console. Refer to
Front Floor Console Replacement
in Instrument Panel, Gages and Console.
- Disconnect the automatic shift lock actuator electrical connector.
- Remove the automatic shift lock actuator from the pivot point (1), the base of the shift lock control and the vehicle.
Installation Procedure
- Install the automatic shift lock actuator to the base of the shift lock control and the pivot point (1).
- Connect the automatic shift lock actuator electrical connector.
- Install the center console. Refer to
Front Floor Console Replacement
in Instrument Panel, Gages and Console.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
Automatic Transmission Shift Lock Control Actuator Replacement Column Shift
Removal Procedure
- Remove the knee bolster bracket. Refer to
Driver Knee Bolster Bracket Replacement
in Instrument Panel, Gages, and Console.
- Disconnect the automatic shift lock actuator electrical connector.
- Remove the actuator from the steering column ball studs.
Installation Procedure
- Install the automatic shift lock control actuator to the steering column ball studs.
- Connect the automatic shift lock actuator electrical connector.
- Place the column in the neutral position.
- Adjust the automatic shift lock control actuator.
4.1. | Pull out the tab (1) on the adjuster block side (2) of the actuator. |
4.2. | Press on the adjuster block (2) in order to compress the internal adjuster spring and disengage the adjuster teeth. Slide the adjuster block as far away from the actuator as possible. |
4.3. | Lock in place by pushing in on the tab (1). |
- Inspect the actuator.
• | The actuator must lock the shift lever clevis when you place the clevis in the park position. |
• | If you can move the shift lever without pressing on the brake pedal, readjust the actuator. |
- Install the knee bolster bracket. Refer to
Driver Knee Bolster Bracket Replacement
in Instrument Panel, Gages, and Console.