The sunshades can be equipped with an illuminated vanity mirror. The illuminated vanity mirror is not serviced as a separate unit.

1. Position the sunshade so the bottom edge is pointing straight down.
2. Remove the sunshade from the sunshade anchor and position the sunshade between the sunshade anchor and the windshield.
3. Remove the screws from the sunshade.
4. Once the retainer shaft releases the sunshade will begin to separate from the bezel. Some back-and-forth movement may be necessary to release sunshade from the retainer.
5. Disconnect the electrical connector from the sunshade if equipped.
6. Remove the sunshade from the vehicle.

1. Connect the electrical to the sunshade connector if equipped.
2. Position the sunshade to the mounting point at the roof.
3. Position the sunshade just behind the sunshade anchor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the sunshade screws.

Tighten
Tighten the sunshade screws to 2 N·m (18 lb in).

5. Position the sunshade into the sunshade anchor.