Removal Procedure
- Apply the parking brake.
- Using a small, flat-bladed tool, gently remove the bezel from the ignition
lock cylinder.
- If the vehicle is equipped with a column shift, position the transaxle
shift control indicator to 1.
- Adjust the steering wheel for access.
- For the Impala, remove the right and the
left access covers from the instrument panel (I/P) fuse block.
For the Monte Carlo, remove the left access cover from the I/P fuse block.
- Remove the steering column filler. Refer to
Steering Column Opening Filler Replacement
in Instrument Panel, Gages, and Console.
- For the Monte Carlo, open the instrument panel compartment door.
- Remove the I/P cluster trim plate screws.
- Start at the left side of the I/P cluster trim plate. Grasp the trim
plate and carefully pull rearward. Disengage the I/P cluster trim plate in order
to easily access the hazard warning switch.
- Disconnect the electrical connector from
the hazard warning switch.
- Remove the hazard warning switch from the I/P cluster trim plate.
Installation Procedure
- Install the hazard warning switch to the
I/P cluster trim plate.
- Connect the electrical connector to the hazard warning switch.
- Press the I/P cluster trim plate into the
I/P trim pad, until all of the retainers are fully seated.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the I/P cluster trim plate screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- For the Monte Carlo, install the left access cover to the I/P fuse block.
For the Impala, install the right and the left access covers to the I/P fuse
block.
- Install the steering column filler. Refer to
Steering Column Opening Filler Replacement
in Instrument Panel, Gages, and Console.
- For the Monte Carlo, close the I/P compartment door.
- Reposition the steering wheel to the original
position.
- If the vehicle is equipped with column shift, position the transaxle
shift control indicator to Park.
- Install the bezel to the ignition lock cylinder.
- Release the parking brake.