GM Service Manual Online
For 1990-2009 cars only

Emergency Vehicle Rear Compartment Lid Lamp Replacement Impala RPO T53

Removal Procedure


    Object Number: 556315  Size: SH
  1. Open the rear compartment.
  2. Disconnect the electrical connectors from the rear compartment lid lamp(s).
  3. Disconnect the electrical connector from the flasher fuse (1).
  4. Remove the flasher fuse (1) if required.

  5. Object Number: 458334  Size: SH
  6. Drill out the rivets from the rear compartment lid lamp bracket(s).
  7. Remove the rear compartment lid lamp(s) from the rear compartment lid.

Installation Procedure


    Object Number: 458334  Size: SH
  1. Position the rear compartment lid lamp(s) from the rear compartment lid.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the rivets to the rear compartment lid lamp bracket(s).

  4. Object Number: 556315  Size: SH
  5. Install the flasher fuse (1) if required.
  6. Connect the electrical connector to the flasher fuse (1).
  7. Connect the electrical connectors to the rear compartment lid lamp(s).
  8. Close the rear compartment.