Emergency Vehicle Rear Lamp Replacement Impala RPO 6J6

1. Remove the rear seat back. Refer to Rear Seat Back Replacement .
2. Remove the bolts from the rear window panel lamp bracket(s).



3. Disconnect the electrical connector(s).
4. Remove the rear window panel lamp(s) from the rear window panel.

1. Connect the electrical connector.



2. Position the rear window panel lamp bracket(s) to the rear window panel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the bolts to the rear window panel bracket(s).

Tighten
Tighten the window panel bolts to 3 N·m (27 lb in).

4. Install the rear seat back. Refer to Rear Seat Back Replacement .