Tools Required

J 38778 Door Trim Pad Clip Remover

1. Drill out the plastic rivit from the rear fascia extension corner if equipped.
2. Remove the rear bumper fascia extension screw if equipped.



3. Remove the rear bumper fascia splash shield nuts.



4. Remove the rear bumper fascia splash shield bolt.



5. Remove the rear bumper fascia push-in retainer using J 38778 .



6. Remove the rear bumper fascia splash shield screws.
7. Remove the rear bumper fascia splash shield.

1. Install the rear bumper fascia splash shield over the studs.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the rear bumper fascia splash shield nuts.

Tighten
Tighten the rear bumper fascia splash shield nuts to 2 N·m (18 lb in).




3. Install the rear bumper fascia splash shield bolt.

Tighten
Tighten the rear bumper fascia splash shield bolts to 2 N·m (18 lb in).




4. Install the rear bumper fascia splash shield screws.

Tighten
Tighten the rear bumper fascia splash shield nut to 2 N·m (18 lb in).




5. Install the rear bumper fascia splash shield push-in retainers.



6. Using a new plastic rivit,install the plastic rivit to the rear fascia extension corner to splash shield if equipped.
7. Install the rear bumper fascia extension screw to the rear fascia extension corner to splash shield if equipped.

Tighten
Tighten the rear bumper fascia extension screw to 2 N·m (18 lb in).