Battery positive voltage is supplied directly to the malfunction indicator lamp (MIL). The powertrain control module (PCM) turns the MIL ON by grounding the MIL control circuit.
The MIL is located on the instrument panel (IPC).
• | The MIL informs the driver that a malfunction has occurred and the vehicle should be taken in for service as soon as possible. |
• | The MIL illuminates during a bulb test and a system test. |
• | A DTC will be stored if a MIL is requested by the diagnostic. |
• | The MIL will illuminate with ignition switch ON and the engine not running. |
• | The MIL will turn OFF when the engine is started. |
• | The MIL will remain ON if the self-diagnostic system has detected a malfunction. |
• | The MIL may turn OFF if the malfunction is not present. |
• | If the MIL is illuminated and then the engine stalls, the MIL will remain illuminated so long as the ignition switch is ON. |
• | If the MIL is not illuminated and the engine stalls, the MIL will not illuminate until the ignition switch is cycled OFF, then ON. |
If the problem is intermittent, refer to Intermittent Conditions .
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module Connector End Views | |||
1 | Did you perform the Diagnostic System Check-Engine Controls? | Go to Step 2 | |
Is the MIL illuminated? | Go to Step 3 | Go to Step 5 | |
3 |
Did you find and correct the condition? | Go to Step 6 | Go to Step 4 |
4 | Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console. Did you complete the replacement? | Go to Step 6 | -- |
5 | Replace the PCM. Refer to Powertrain Control Module Replacement . Did you complete the replacement? | Go to Step 6 | -- |
6 |
Does the vehicle operate correctly without any MIL illumination, and without any stored DTCs? | System OK |