Front Floor Console Replacement Impala
Removal Procedure
- Remove the trim plate
from the front floor console. Refer to
Front Floor Console Trim Plate Replacement
.
- Remove the following front floor console bolts:
• | Near the instrument panel (IP) |
• | At the transaxle shift control lever |
• | Under the mat in the rear bin |
- Pull the console rearward in order to disengage the clips from
the IP.
- Disconnect the electrical
connectors.
- Remove the front floor console.
Installation Procedure
- Position the front floor
console to the vehicle.
- Connect the electrical connectors.
- Install the front floor
console. Engage the clips at the IP.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the following
front floor console bolts:
• | Near the instrument panel (IP) |
• | At the transaxle shift control lever |
• | Under the mat in the rear bin |
Tighten
Tighten the bolts to 12 N·m (106 lb in).
- Install the trim plate to the front floor console. Refer to
Front Floor Console Trim Plate Replacement
.
Front Floor Console Replacement Monte Carlo
Removal Procedure
- Remove the trim plate
from the front floor console. Refer to
Front Floor Console Trim Plate Replacement
.
- Disconnect the wiring harness connector and retainer.
- Open the console storage compartment.
- Remove the storage compartment mat.
- Remove the bolts from the bottom of the storage compartment.
- Remove the console bolts forward of the shift control lever.
- Remove the front floor console.
Installation Procedure
- Install the front floor
console.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the console
bolts forward of the shift control lever and at the bottom of the storage
bin.
Tighten
Tighten the console bolts to 12 N·m (106 lb in).
- Install the storage compartment mat.
- Close the console storage compartment.
- Connect the wiring harness connector and retainer.
- Install the front floor console trim plate. Refer to
Front Floor Console Trim Plate Replacement
.