GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 190564  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine oil drain plug in order to drain the engine oil.

  3. Object Number: 441263  Size: SH
  4. Disconnect the oil level sensor electrical connector.
  5. Remove the engine oil level sensor from the oil pan.

Installation Procedure


    Object Number: 441263  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the engine oil level sensor to the oil pan.
  2. Tighten
    Tighten the sensor to 20 N·m (15 lb ft).

  3. Connect the oil level sensor electrical connector.

  4. Object Number: 190564  Size: SH
  5. Install the engine oil drain plug.
  6. Tighten
    Tighten the plug to 30 N·m (22 lb ft).

  7. Lower the vehicle.
  8. Fill the crankcase with engine oil. Refer to Engine Oil and Oil Filter Replacement .