Removal Procedure
- Remove the garnish moldings
from the left and the right windshield pillar. Refer to
Windshield Pillar Garnish Molding Replacement
in interior Trim.
- Starting at the right side of the windshield, carefully lift upwards
on the defroster grille in order to release the retainers. Continue working
to the left until all of the retainers are released.
- Disconnect the daytime
running lamps (DRL) sensor from the defroster grille.
- Remove the defroster grille.
Installation Procedure
- Position the defroster
grille to the upper IP. Connect the DRL sensor to the defroster grille. Verify
that the DRL sensor wiring harness will not be pinched when the defroster
grille is installed.
- Starting at the left side,
install the defroster grille retainers into the upper IP. Continue working
to the right until all of the retainers are installed.
- Install the garnish moldings to the right and the left windshield
pillar. Refer to
Windshield Pillar Garnish Molding Replacement
in Interior Trim.