For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Drill out the plastic rivits from the front bumper fascia extension corner to the front fender liner.
- Remove the lower fascia support. Refer to Front Bumper Fascia Lower Support Replacement in Bumpers.
- Remove the front fender liner to front bumper fascia screws.
- Remove the spring clips from the fascia extension.
- Remove the fascia extension.
Installation Procedure
- Position the fascia extension to the fascia.
- Install the spring clips starting at the center of the fascia extension and working outward.
- Install the screws to the front fender liner at the front of the front bumper fascia.
- Using new plastic rivits, install the 2 plastic rivits to the front bumper fascia extension corner and front fender liner.
- Install the lower fascia support. Refer to Front Bumper Fascia Lower Support Replacement in Bumpers.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the front fender liner to fascia screws to 2 N·m
(18 lb in).
