GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution:  When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.


    Object Number: 363782  Size: SH
  1. Remove the hood. Refer to Hood Replacement .
  2. Remove the hood rear side seal. Refer to Hood Rear Outer Seal Replacement .
  3. Remove the hood assist rod. Refer to Hood Open Assist Rod Replacement .
  4. Loosen the hood hinge to fender bolts, but do not remove the bolts.

  5. Object Number: 363781  Size: SH
  6. Center punch the spot weld.

  7. Object Number: 363778  Size: SH
  8. Drill out the spot weld using a 9.5 mm (3/8 in) drill bit.
  9. Remove the hood hinge to fender bolts.
  10. Remove the hood hinge from the fender.
  11. Repair the paint on the fender where the hood hinge was removed. Refer to Anti-Corrosion Treatment and Repair .

Installation Procedure

Important: Weld on body side is an assembly plant assembly aid only. Weld is not required when installing a replacement hinge.


    Object Number: 363782  Size: SH
  1. Align the hood hinge to the fender.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the hood hinge to fender bolts.
  4. Tighten
    Tighten the hood hinge to fender bolts to 25 N·m (18 lb ft).

  5. Install the hood. Refer to Hood Replacement .
  6. Install the hood assist rod. Refer to Hood Open Assist Rod Replacement .
  7. Install the hood rear side seal. Refer to Hood Rear Outer Seal Replacement .
  8. Adjust the hood, as required. Refer to Hood Adjustment .