Rear Side Door Window Outer Sealing Strip Replacement Impala

1. Position the rear window all the way down.
2. Remove the rear door trim panel to have access to these screws. Refer to Rear Side Door Trim Panel Replacement .



3. Remove the rear door outer belt sealing strip screws.



4. Remove the rear window outer belt sealing strip by pulling the sealing strip from the rear door pinch-weld flange.

1. Position the rear door outer belt sealing strip to the rear door pinch-weld flange.



2. Install the rear door outer belt sealing strip to the pinch-weld flange, pressing into place until full seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the rear door outer belt sealing strip screws.

Tighten
Tighten the rear door outer belt sealing strip screws to 2 N·m (18 lb in).

4. Install Rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .