Schematic Reference: Door Lock/Indicator Schematics

Connector End View Reference: Power Door Systems Connector End Views

Did you perform the Door Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Door Systems

Verify that the key cylinder switches power door locks inoperative fault is present.

Does the key cylinder switches power door locks system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Does the power door locks system operate normally?

Go to Step 4

Go to Symptoms - Doors

1. Install a scan tool.
2. Turn the ignition ON, with the engine Off.
3. Lock the driver door.
4. With a scan tool, observe the key cylinder unlock parameter in the Body Control Module data list.
5. Activate the driver door lock cylinder to the UNLOCK position.

Does the scan tool display Active?

Go to Step 5

Go to Step 6

1. Lock the front passenger door.
2. With a scan tool, observe the key cylinder unlock parameter in the Body Control Module data list.
3. Activate the passenger door lock cylinder to the UNLOCK position.

Does the scan tool display Active?

Go to Step 9

Go to Step 6

1. Disconnect the appropriate door lock cylinder switch.
2. Connect a 3 amp fused jumper wire between the driver door key switch signal circuit of the door lock cylinder switch and the ground circuit of the door lock cylinder switch.
3. With a scan tool, observe the key cylinder unlock parameter in the Body Control Module data list.

Does the scan tool display Active?

Go to Step 10

Go to Step 7

Test the driver door key switch signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 8

Test the ground circuit of the appropriate key cylinder unlock switch for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 9

Inspect for poor connections at the harness connectors of the body control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Inspect for poor connections at the harness connectors of the key cylinder unlock switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

1. Perform the set-up procedure for the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.
2. Replace the body control module. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 13

--

Replace the key cylinder unlock switch. Refer to Front Side Door Lock Actuator Replacement .

Did you complete the repair?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you find and correct the condition?

System OK

Go to Step 2