The power sunroof system consists of the following components:

The power sunroof will operate with the ignition switch turned to Accessory or RUN. Once the ignition switch is turned to OFF the sunroof will continue to operate until any door is open or when the Retained Accessory Power (RAP) has timed out. For a description and operation of the RAP operation, refer to Retained Accessory Power (RAP) Description and Operation in Retained Accessory Power.

Use the rocker type sunroof switch, located in the front center of the headliner, to command the sunroof to:

Pressing the sunroof switch rearward, the sunroof glass will slide from:

Pressing the sunroof switch forward, the sunroof glass will slide from:

To open the power sunroof to the vent position from the closed position, turn the ignition to ON, with engine OFF. Momentarily press the sunroof switch rearward, this will apply the sunroof switch low reference to the sunroof open signal circuit 5 volt reference input to drop to 0 volts. As long as the sunroof control module only sees a single input request from the sunroof switch open signal circuit, the control module will automatically express open the sunroof glass to the full vent position, raising the rear of the glass upward. The sunroof glass will soft stop at the full vent position based on the inputs from the limit switches. The sunshade will have to be manually slid closed. To stop the sunroof glass in a desired vent position other than full open either:

The express open will work only with the glass in between the full vent and partial open positions. To express open the power sunroof, turn the ignition ON, with engine OFF. Momentarily press less than 1.5 seconds the sunroof switch rearward once, this will apply the sunroof switch low reference to the sunroof switch signal open signal circuit 5 volt reference input to drop to 0 volts momentarily. The momentary 0 volts input to the sunroof control module indicates an express open request. The sunroof glass will slide automatically (express open) above the roof. The sunroof glass will soft stop at the full open position based on the inputs from the limit switches. As the sunroof glass expresses open so will the sunshade. To stop the sunroof glass in a desired position other than to the express open position:

To close the power sunroof, turn the ignition ON, engine OFF, and from the any position press and hold the sunroof switch forward, this will apply the sunroof switch low reference to the sunroof close signal circuit 5 volt reference input to drop to 0 volts. The sunroof switch close signal input to the sunroof control module needs to have a constant 0 volts applied to allow the motor to continue to drive the sunroof glass past the vent position until it reaches the closed position. The sunroof glass will soft stop at the closed position based on the inputs from the limit switches. The wind deflector will retract prior to the glass reaching the fully closed position. To close the sunshade, this will have to be manually slid closed.

The sunroof has a bi-directional motor. When the motor is not operating both circuits are grounded. When the motor drives the sunroof glass in the direction from the closed to vent or vent to open position, the following occurs:

When the motor drives the sunroof in the direction from the open to vent or vent to closed position, the following occurs:

The sunroof control module is equipped with a timer circuit which stops the operation of the sunroof motor after 8 seconds.

The Sunroof Opening Position Switch tracks the position of the glass through 2 limit switches:

The sunroof control module monitors the limit switches and based on the inputs determines the position of the sunroof glass. As a limit switch closes, the 5 volt reference will be shorted to the sunroof limit switch low reference circuit, pulling the 5 volt reference to 0 volts.

The sunroof control module understands the position of the sunroof glass based on the different input combinations through the soft stop and vent limit switch inputs.