GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Monte Carlo 🢒 Body and Accessories 🢒 Body Rear End 🢒 Rear Compartment Lid Release Switch Replacement

Removal Procedure

    Object Number: 519517 Size: SH
  1. Release the LH instrument panel (IP) insulator tabs from the lower IP trim pad retainers for access.
  2. Remove the LH fuse block access cover.
  3. Remove the steering column opening filler panel screws.
  4. Release the steering column opening filler panel retainers from the IP lower trim panel. Carefully lower the steering column opening filler panel away from the IP lower trim panel.

    5. Object Number: 519506 Size: SH
  5. Disconnect the electrical connector from the rear compartment release switch.
  6. Remove the rear compartment release switch.

Installation Procedure

    Object Number: 519506 Size: SH
  1. Install the rear compartment release switch.
  2. Connect the electrical connector to the rear compartment release switch.

    3. Object Number: 519517 Size: SH
  3. Align the steering column opening filler panel to the instrument panel (IP) lower trim panel. Install the steering column opening filler panel retainers to the IP lower trim panel.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the steering column opening filler panel screws.

    5. Tighten
    Tighten the steering column opening filler panel screws to 2 N·m (18 lb in).

  5. Install the LH IP insulator tabs to the lower IP trim pad retainers.
  6. Install the LH fuse block access cover.