Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
2. Remove the radiator. Refer to Radiator Replacement in Engine Cooling.



3. Remove the A/C line coupling from the condenser tube to the receiver dehydrator tube. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .



4. Remove the A/C compressor line nut from the condenser and position the A/C compressor line aside.
5. Remove the condenser from the vehicle.
6. Remove and discard the O-ring seals and seal washer.

1. If replacing the condenser, add refrigerant oil to the condenser. Refer to Refrigerant System Capacities for system capacity information.
2. Install the condenser to the vehicle.
3. Install a new seal washer onto the A/C compressor hose. Refer to Sealing Washer Replacement .
4. Install new O-ring seals onto the receiver dehydrator tube. Refer to O-Ring Replacement .



5. Install the receiver dehydrator tube to the condenser.
6. Install the A/C line coupling to the receiver dehydrator tube and the condenser tube. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .



7. Install the A/C compressor hose to the condenser.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

8. Install the A/C compressor hose block fitting nut to the condenser.

Tighten
Tighten the nut to 17 N·m (13 lb ft).

9. Install the radiator. Refer to Radiator Replacement in Engine Cooling.
10. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
11. Leak test the fittings of the component using J 39400-A .