Removal Procedure
- Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
- Disconnect the electrical connector from the recirculation actuator.
- Remove the recirculation actuator electrical harness from the recirculation housing clips.
- Remove the recirculation housing retaining screws.
- Remove the recirculation housing from the HVAC module assembly.
- Remove the screws from the recirculation actuator.
- Remove the recirculation actuator.
Installation Procedure
- Align the retaining tabs and install the recirculation housing to the HVAC module assembly.
- Install the recirculation housing screws.
- Align the slots on the recirculation actuator to the slots on the recirculation door shaft.
- Install the recirculation actuator on to the recirculation door shaft.
- Install the recirculation actuator screws.
- Install the recirculation actuator electrical harness to the recirculation housing clips.
- Connect the electrical connector to the recirculation actuator.
- Install the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.
