Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B1516 08 : Battery Current Sensor Signal InvalidDTC B1516 66 : Battery Current Sensor Wrong Mounting Position
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Battery Current Sensor Supply Voltage | B1516 08 | B1516 08 | -- | -- |
Battery Current Sensor Signal Circuit | B1516 08 | B1516 08 | -- | -- |
Battery Current Sensor Low Reference Circuit | -- | B1516 08 | -- | -- |
Circuit/System Description
The battery current sensor is a 3-wire hall effect current sensor. The battery current sensor monitors the battery current. It directly inputs to the body control module (BCM). It creates a 5-volt pulse width modulation (PWM) signal of 128 Hz with a duty cycle of 0-100 percent. Normal duty cycle is between 5-95 percent. Between 0-5 percent and 95-100 percent are for diagnostic purposes.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | The engine is running. |
Conditions for Setting the DTC
B1516 08
The BCM detects a duty cycle of PWM input signal is less than 4 percent or more than 96 percent for more 33 seconds.
B1516 66
The BCM detects the battery current sensor is improperly installed.
Action Taken When the DTC Sets
The DTC sets as current , no driver indication or message is displayed.
Conditions for Clearing the DTC
The DTC clears as current status when the battery sensed current returns to normal range for more than 5 seconds.
Reference Information
Schematic Reference
Starting and Charging Schematics
Connector End View Reference
Engine Electrical Connector End Views
Electrical Information Reference
Circuit/System Testing
B1516 08
Battery Current Sensor Signal Invalid
- Ignition OFF, disconnect the harness connector at the battery current sensor.
- Ignition OFF, verify a test lamp illuminates between B+ and the low reference circuit terminal B.
- Ignition ON, test for 5 volts between the battery current sensor supply voltage circuit terminal A and ground.
- Test for 5 volts between the battery current sensor signal circuit terminal C and ground.
- If all circuits test normal test or replace the battery current sensor.
| ⇒ | If the test lamp did not illuminate , test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the BCM. |
| ⇒ | If less than the specified range , test the battery current sensor supply voltage circuit terminal A for a short to ground or an open/high resistance. If the circuit test normal replace the BCM. |
| ⇒ | If less than 5 volts test the battery current sensor signal circuit terminal C for a short to ground or an open/high resistance. If the circuit test normal replace the BCM. |
B1516 66
When diagnosing B1516 66 verify that the battery current sensor is installed securely and positioned in the correct current flow direction.
| ⇒ | If the battery current sensor is not, remove and reinstall the sensor properly. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
