Dome Lamp Replacement Impala

Dome Lamp Replacement Monte Carlo

Dome Lamp Replacement Impala w/SEO, RPO 6C7

1. Remove the (TRK/ROOF BRP) fuse before starting dome lamp removal procedures. Refer to Power and Grounding Component Views .
2. Remove the dome lamp lens from the dome lamp bezel using a small flat-bladed tool.



3. Remove the dome lamp bulb.

Important: Hold the dome lamp bezel in position when removing the screws from the dome lamp bezel. Remove the dome lamp bezel slowly to avoid loosing the dome lamp spacers.

4. Remove the screws from the dome lamp bezel.



5. Remove the dome lamp bezel from the headliner (5).
6. Disconnect the electrical connector if required.

1. Connect the electrical connector if required.
2. Position the done lamp spacers and wiring harness ground terminal to the dome lamp bezel and screws (3).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the dome lamp bezel as an assembly to the dome lamp bracket with the dome lamp switch to the rear.

Tighten
Tighten the dome lamp screws to 1.5 N·m (17 lb ft).

4. Install the dome lamp bulb.



5. Install the dome lamp lens.
6. Install the (TRK/ROOF BRP) fuse. Refer to Power and Grounding Component Views .