GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Monte Carlo 🢒 Body Systems 🢒 Lighting 🢒 High Mount Stop Lamp Replacement

High Mount Stop Lamp Replacement Monte Carlo

Removal Procedure

    Object Number: 669080 Size: SH
  1. Open the rear compartment.
  2. Remove the screw from the high mounted stoplamp bracket.
  3. Remove the high mounted stoplamp bracket.

    4. Object Number: 458174 Size: SH
  4. Remove the screws from the high mounted stoplamp.
  5. Depress the retainers holding the high mounted stoplamp to the inner panel of the compartment lid .
  6. Remove the high mounted stoplamp from the rear compartment lid inner panel.

    7. Object Number: 458181 Size: SH
  7. Disconnect the electrical connector from the high mounted stoplamp.

Installation Procedure

    Object Number: 458181 Size: SH
  1. Connect the electrical connector to the high mounted stoplamp.

    2. Object Number: 458174 Size: SH
  2. Install the high mounted stoplamp pressing in until the retainers are fully seated.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws to the high mounted stoplamp.

    4. Tighten
    Tighten the high mounted stoplamp screws to 2 N·m (18 lb in).


    Object Number: 669080 Size: SH
  4. Install the high mounted stoplamp bracket.
  5. Install the screw to the high mounted stoplamp bracket.

    6. Tighten
    Tighten the high mounted stoplamp bracket screw to 2 N·m (18 lb in).

  6. Close the rear compartment.

High Mount Stop Lamp Replacement Impala


Object Number: 1596324 Size: SF

Callout

Component Name

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Remove the rear interior compartment lid trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .

1

Nuts, High Mounted Stop Lamp Assembly (Qty: 2)

Tighten
4 N·m (35 lb in)

2

Lamp Assembly, High Mounted Stop

Tip

    • Remove the high mounted stop lamp from the inside of the rear compartment lid mounting studs.
    • Disconnect the electrical connector to the high mounted stop lamp.

3

Studs, Rear Compartment Inner Panel

Tip
Ensure the studs are secure to the inner compartment panel upon reassemble.