GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Monte Carlo 🢒 Body Systems 🢒 Lighting 🢒 Tail Lamp Bulb Replacement

Tail Lamp Bulb Replacement Impala


Object Number: 1602798 Size: SF

Callout

Component Name

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Remove either the LR or RR tail lamp assembly. Refer to Tail Lamp Replacement .

1

Bulb, Rear Park Lamp

Tip
Turn the lamp socket counterclockwise in order to remove.

2

Bulb, Park and Turn Signal Assembly

Tip
Pull the bulb straight out of the lamp socket.

3

Bulb, Rear Back Up Assembly

Caution: Refer to Halogen Bulb Caution in the Preface section.

Tip
Remove the bulb from the lamp socket by pulling the bulb straight outward from the socket.

Tail Lamp Bulb Replacement Monte Carlo

Removal Procedure

    Object Number: 458222 Size: SH
  1. Open the rear compartment.
  2. Remove the upper wingnut from the tail lamp.
  3. Pull back the rear compartment trim panel from the tail lamp.
  4. Remove the lower wingnuts from the tail lamp.
  5. Remove the tail lamp from the rear body panel.

    6. Object Number: 458223 Size: SH
  6. Disconnect the electrical connector to the tail lamp.

    7. Notice: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.

  7. Disconnect the electrical connector from the tail lamp.
  8. Remove the tail lamp socket, turning counterclockwise.
  9. Remove the bulb from the tail lamp socket.
  10. Remove the sidemarker lamp socket, turning counterclockwise.
  11. Remove the bulb from the sidemarker lamp socket.

Installation Procedure

    Object Number: 458223 Size: SH
  1. Install the bulb to the tail lamp socket.
  2. Install the bulb to the sidemarker lamp socket.
  3. Install the sidemarker lamp socket, turning clockwise.
  4. Install the tail lamp socket, turning clockwise.

    5. Notice: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.


    Object Number: 738424 Size: SH
  5. Connect the electrical connector to the tail lamp.

    6. Object Number: 458222 Size: SH
  6. Install the tail lamp to the rear body panel
  7. Install the lower wingnuts to the tail lamp.
  8. Pull back the rear compartment trim panel to the tail lamp.
  9. Install the upper wingnut to the tail lamp.
  10. Close the rear compartment.